Weathered pine

Sample process:

Dark weathered pine

• Substrate material: pine, knotty pine, knotty spruce in solid wood or slip-matched veneer with a veneer thickness of at least 0.7 mm, preferably 1 mm
• preferably 1 mm, with Andalon brushes
• Antique Pre-Stain WAV 58-20500
• Dry for at least 3 hours at room temperature 20 °C
• Sand with sanding sponge grain 150 to produce an effect until the hard growth rings are exposed untreated
• Spray on one coat of Antique Post-Stain WA 58-20506 until nicely damp, without wiping
• Dry for at least 3 hours at room temperature 20 °C
• Apply two top coats of FANTASTIC-NATURA DA 48660 with intermediate sanding grain 320 mixing ratio (by volume) 10 : 1 with PU Hardener DR 4071
• Dry for at least 16 hours at room temperature 20 °C

Please observe the latest technical information and the material safety data sheets for the stated individual products.

• In addition to selection and texturing of the bare wood, the application quantity and sanding of the stain also have a crucial influence on the effect produced.
• PU lacquers should not be used or dried at material or room temperatures below 18 °C.
• Please sand back the PU lacquered surfaces before applying fresh lacquer and apply coatings to the sanded surfaces as soon as possible to avoid adhesion problems.
• Final hardness of the coating is achieved after one week in correct storage conditions (at least 20 °C room temperature).
• Please conduct a test coating under real conditions.

This information is purely advisory and is based on the best knowledge available after careful research in line with current state of the art technology. It is not legally binding. We also refer you to our Terms and Conditions. The material safety data sheet according to regulation (EC) No. 1907/2006 is available on request.